Dual-Scale Fret Slotting Template 24.75 & 25.5"
Dual-Scale Fingerboard Slotting Template · 24.75 & 25.5"
Made from clear 5 mm Plexiglas, this template measures approximately 580 × 75 mm, with one scale along each edge. Each scale has 24 fret indexing notches plus a zero fret/nut reference position. The notches are 2 mm wide and require a 2 mm indexing pin. A straight nail with a 2 mm shank can also serve as the pin if it fits securely in your jig. A guitar-shaped reference card showing common scale lengths is included.
How to use
- Select the scale you need and align the Zero/Nut mark with the corresponding reference line on your fingerboard blank.
- Secure the blank with a few short, narrow strips of thin double-sided tape. Use just enough tape to hold it firmly and check that the blank cannot shift before sawing.
- Seat the indexing pin fully in each notch as you cut the required fret slots.
Removing the blank
The acrylic can crack if flexed. Keep the template flat and fully supported on your bench. Slide a thin shim or flexible scraper between the blank and the template, keeping it flat as you work through each strip of tape. Lift the blank only once all the tape has released. Avoid pulling the pieces apart or levering against the acrylic.


